Replaced sump assembly and tested operation. Working great no leaks good to go

Electrolux Dryer Repair. Customer mentioned dryer was smelling like gas recently when it was running. Dryer vent was disconnected on back and was venting the hot air smells into the laundry room. Reconnected dryer venting. Ran dryer the entire time and could not detect any gas smells. Did a leak down test on the gas fitting going into the back of the dryer. There were no gas leaks that I could smell or find. Dryer is working well.

"Repaired wire pulled out from icemaker connector. No more error codes in freezer now. Cycled the icemaker, the tray has mechanical movement but it does not fill with water. Unit was pulled out for further testing.Copper lines on compressor appear to have been re-soldered at some point and are sloppily connected.I also found electrical connector to water valve was unplugged. Plugged in and still does not pass water to the icemaker on demand in diagnostics. Board is sending out 120VAC to water valve constantly whether its on or off, but when connected to the water valve, voltage drops to 0 whether it is in test mode or not. Needs board, part # 5304529960 which I ordered from Dey.Customer phone 6518158509; ordrd 1 5304529960 (PC Board)"

Tech was assigned as a helper;

Evaporator cover frozen solid with ice build-up. Steamed ice and forced a defrost mode which works well and activates the heater which is working just fine. Replaced thermistor in evap section and main control board.