Appliance Repair Scandia Minnesota
Omega Force Appliance Repair Rated 5.0 out of 5 stars based on 1 customer reviews
We serviced a
BOSCH DISHWASHER
Model SHPM65Z55N/20
Near Scandia, MN 55073
Aaron
Job Details:
02/11/2025
I access the aqua sensor on the sump assembly. I replaced the aqua sensor and secured it on its home in the sump assembly. I accessed the user control interface on the top of the door. I removed the defective board. There was some sticky material on the Buttons for the user control so I cleaned that off as best I could. Then I replaced the user control board. I secured the door back in place and positioned the dishwasher back into its home. I ran a test cycle to confirm that the machine fills washes drains and other functions are correct. The dishwasher is good for normal every day use.
We serviced a
BOSCH DISHWASHER
Model SHPM65Z55N/20
Near Scandia, MN 55073
Aaron
Job Details:
02/04/2025
The dishwasher produced error code E:18 for me, refers to a bad water inlet and defective aqua sensor. The dishwasher fills fine, the water inlet isnt the problem. The user interface buttons feel sticky and do not consistently respond to selection. I built an estimate for a user interface module (
We serviced a
FRIGIDAIRE REFRIGERATOR
Model GRFS2853AFA
Near Scandia, MN 55073
Aaron
Job Details:
01/02/2025
The customers, fresh food doors are bouncing open when one door is closed. I explained that the force of air pressure from one door being closed, can push other doors open, especially when the freezer door is closed. It can force the fresh food doors into an open position. I did adjust the front legs to give the appliance more tilt front to back. I adjusted each leg up about 3/8 of an inch, that did seem to improve the movement when the freezer door was closed. I did adjust the height of the two fresh food doors to make them level.
We serviced a
LG REFRIGERATOR
Model LFXS29766S.ASTCNA0
Near Scandia, MN 55073
Aaron
Job Details:
12/20/2024
The high and low side pressures indicated a failed compressor on this appliance. This was the second compressor to go into this appliance. I recovered the refrigerant and cut out the defective compressor. I cleaned, prepped and braised in a new compressor and filter dryer, pulled a deep vacuum. Once hardware was in and charged with 5.11 ounces of refrigerant. Once power was restored to the refrigerator the compressor began to cycle refrigerant exactly as expected. I told the customer to wait 24 hours of temperature being maintained before loading food back into their refrigerator.
We serviced a
FRIGIDAIRE REFRIGERATOR
Model GRFS2853AFA
Near Scandia, MN 55073
Lucas
Job Details:
12/05/2024
Raised door and leveled. Mullion now engages perfectly. Good to go
Scandia, Minnesota
LG REFRIGERATOR
LFXS29766S.ASTCNA0







12/24/2024