Installed suspension rods, leveled unit and recalibrated it after rods went in. Ran thru diagnostic test perfect and spinning good. Good to go

Replaced door switch due to it being broken. Installed and tested operation. Working good now; used 1 3406107 (DOOR SWITCH) from stock

Installed parts from last diagnosis once installed tested unit is working properly

"Upon arrival, I removed the old compressor and flush the system with nitrogen. At this point, it seemed as though there could possibly be a blockage in the high side, and so I used high-pressure nitrogen to attempt to flush it out. It appeared to have worked, and I was able to get the blockage out-of-the-way. Replace the failed compressor with a new compressor and soldered it in. Check the seal system for leaks. Pull the vacuum and then charge the system with refrigerant. Let the machine run for a bit and check the freezer temperature at 37?. Everything seems to be working properly now. ; saved tckt , states that autho needed"

Machine has a failed compressor that will need to be replaced to get this machine cooling again. Ordered a compressor from day and will return on Tuesday. ; ordrd 1 5304532451 (Compressor)