Notes from real Omega Force service calls: the appliance, the problem we found and how we fixed it.
Repairs completed September 12, 2025 to September 15, 2025
Asko DryerStackedSep 12, 2025Minneapolis, MNTechnician: Collin
Model T701
Upon inspection pulled both units out on floor mat took whole front off replaced belt verifying all three connection of housing exhaust. Click back into place unit sounds great heating spinning done.
“Our repair required and ordered part. Repair completed as agreed. We'll call Omega and ask for Collin when we need help in the future.”
Mike H.
LG RefrigeratorSep 12, 2025New Brighton, MNTechnician: Collin
Model LMXC23796S/00
Uninstalled freezer evaporator and installed new freezer evaporator fan assembly verified after installation. Unit sounds great running great done.
“Collin was friendly, professional and respectful. He did a great job and I would use this service again if needed.”
Sheila F.
LG RefrigeratorSep 12, 2025Vadnais Heights, MNTechnician: Collin
Model LRDCS2603S.ASTCNA0
Did a full diagnostic cycle, verified operations from damper controls, fan motors, and communication from board to compressor is proper. Unit had frost on back freezer wall. Advised could be caused by door being ajar. Good to have us out doing testing. Advised to call back in if error codes pop up on user interface display.
“Very satisfied with the knowledge our service technician. I recommend services from this vendor.”
Frigidaire refrigerator. When dispensing water is leaking all around the dispenser area. Found water tubing had been pushed up in dispenser area and was not protruding below dispenser. Removed user interface and repositioned water tubing. Installed zip tie to ensure it does not happen again.
LG WasherLaundry centerSep 15, 2025Hugo, MNTechnician: Collin
Model WKE100HVA.ASSEEUS
Installed both hot and cold solenoids verified, and the valve wasnt leaking from any connection. I did uploaded video to prove that theres no leaks. Working great done
Customer states the dryer is not heating and making noise. Found the bulk head was not on correctly and the heat element had a burnt wire and fuse that was blown. Customer approved the repair. Adjusted the bulkhead and replaced the heat element kit. Cycled and tested the dryer is heating as it should.
Wolf MicrowaveBuilt-inSep 15, 2025River Falls, WITechnician: Michael
Model MWC24
Customer complained of unit not heating, previously diagnosed switch and holder at fault, replaced switches and holder, unit heating and working properly.
“Michael was extremely friendly, professional and efficient.”