"The fresh food temp was 43 and the freezer was in the teens. I was thinking there would be a issue with the evaporator fan because I had issues with it when I replaced the fan last visit but the fan is working now. I removed the evap cover and the frost pattern was a little weak. Today I added refrigerant until the low side pressure was 5 psi. The evaporator immediately started to get a full frost pattern. I verified I am getting air into the fresh food. I advised the customer to wait 24 hours for temps to get back to 0 and 38.

"Today I replaced the evaporator, heat exchanger, filter drier and the evaporator fan motor. I leaked checked the system and then pulled a vacuum and recharged the system. Its all working good.

"The customer said the unit is not cooling good anymore. I pulled the upper cover off and found the heat exchanger was replaced and the evaporator. There was a tap on the compressor low side and on the filter drier. I put my gauges on and found the system is low on refrigerant. I added gas until the low side pressure came up. The low side and the high side pressure both came up. It has a leak in the heat exchanger. It will need a heat exchanger, evap and filter drier. The evaporator fan started to make a lot of noise like the bearings are failing. It was in and off. It will also need that fan motor. Please build a quote and contact the customer. Evaporator 4388574Heat exchanger 2003002Drier Fan motor WP4389155; states that autho needed"

"Customer complaint is, NOT COOLING. Inspected and tested. Freezer is 40F and FF is 55F. I removed the evaporator cover and theres heavy frost on about 5 percent and nothing on the rest. The sealed system has failed. Customer would like a quote on repairing. If refrigerator has to be pulled out its going to be a tight one, FYI. ; saved tckt"

"The control assembly display is blank. The customer had another service company out to try and fix. They replaced the rear main control board and still doing it. They were going to order a new display control, but have not called the customer back. He would like us to fix it. I was unable to get the mall number to pop up. Please look up the control user interface display board and call the customer with a quote. The customer has not been charge for the second appliance trip charge free. Please add that to the quote. ; (serial indicated as 'NotAvailable' so system created UIS w/pseudo #)"